Attentions
1.
Ceiling air leakage
Figure 7.
2.
Figure 8.
3.
•
Figure 9.
AMS-SVX02A-EN
Improper screw tightness may cause fault as shown in fi g. 7.
Air leakage
Water drop condensed and fall
If there is still a seam between ceiling and decoration panel after tightening screws, please
adjust the indoor unit height again (as shown in fi g. 8).
No seams
Ensure no clearances between the unit and panel after installation.
Decoration panel wiring (see fi g. 9).
Connect two joints of air defl ector motor at the panel.
Main
Panel
Without affecting the indoor unit lifting
and drainage pipe are prerequisites for
adjusting the height through holes at
the panel corner.
Main
Panel
Unit Installation
15