Table of Contents
Advertisement
1
ON/OFF Button
Press ON/OFF button to turn on the unit, and repress this
button to turn off the unit. At the time of startup, the unit runs
in the present setting.
2
Temperature (time) setting buttons
Use this set of buttons to set and adjust temperature (or
time). Press these two buttons at the same time to change the
temperature unit ( ℉ /
3
Quick cooling/Quick heating function
When the Quick cooling/Quick heating key of the wired
controller of an indoor unit is pressed, repress to cancel.
Selection of timing function
Press the Quick cooling/Quick heating key for 2s to enter the
timing state. Select any one of the four functions: Timing on/
off, Timing off only, Timing on only, and Timing canceled. Turn
on or turn off the unit according to the current set time.
4
PRI setting
When pressing the PRI setting button of the wired controller of
an indoor unit, the indoor unit is preferred, keep energy supply
preferential, and repress to cancel.
View and setting of timing function
Press the button for 2s to enter Set time view/setting, and
view and display the current state, present time, timing on
time, and timing off time in turn (24h system). Under each
displaying state, press UP/DOWN button within 5s to adjust the
temperature (time).
5
Fan speed setting button
Select the fan speed in high/medium/low/auto mode
6
Swing function button
Press this button once to enable the Swing function, press it
again to disable this function.
7
Sleep function button
8
Selection of operating mode button
Press this button to enable the sleep function in present
operating mode; repress it to shut down or cancel this
function; after 8h, it may be canceled automatically. Cooling/
heating mode of this function is valid: after being canceled,
reset the temperature and fan speed in sleep state.
9
Reset hole
Press the Reset hole, zero the timing of dust fi ltration screen
cleaning, do not display symbol of the screen, and accumulate
the operating time of the air conditioner again.
10
Display of priority
This indoor unit is under the priority setting state or not
AMS-SVX02A-EN
).
Wired Controller Instruction
11
Sleep function Display
While operating in sleep mode, this animation displays
12 Display of operating in auto mode
13 Display of operating in fan mode
14
Display of operating in dry mode
15 Display of operating in heating or quick heating mode
16 Display of operating in cooling or quick cooling mode
17 Display of time, timing function
When pressing the timing setting button, the
corresponding time is displayed in turn: after fi nishing
setting. Display the clock: display selection of timing in
current operating mode.
Display of fault code
If the unit needs stopping for repair or the safety
protection device activates due to system failure, the
fault or protection code is displayed in the time display
are, and fl ashes.
18 Display of set temperature
Display of the set temperature in present operating
state
19
Display of the fan speed
Display the present fan speed selected in animation.
Under the heating cold air protection state, the cold air
protection is not displayed in animation.
20 Display of operating state of the compressor
When the compressor stops, display full idle state. In
operating, display full-load state; in stop, no display.
For the VF compressor, the operating frequency may
be displayed.
21 Display of auxiliary heating
When the auxiliary heating operates, this display
appears.
22 Display of defrosting
Display the system in defrosting mode.
23 Display of dust fi ltration screen
When dust fi ltration screen needs cleaning, this display
appears.
24 Cooling mode setting button
25 Heating mode setting button
25
Advertisement
Table of Contents
