Table of Contents
Advertisement
Unit Installation
Panel Installation
1.
2.
Figure 6.
14
As shown in Fig.6, place the air defl ector motor facing indoor unit pipe mouth.
Panel installation
Install the panel on the indoor unit temporarily. Put the buckle at the hook (2 positions) in
the opposite air defl ector motor side.
Put the residual 2 buckles at the main hook temporarily (air defl ector motor wires can not
be involved in sealing materials).
Torque the 4 hexagonal screws below the hook to 15mm (the panel will be lifted later).
As shown in fig.
, adjust the panel in arrow direction for good connection between
regulation plate and the ceiling.
Tighten screws till the thickness of sealing materials between panel and indoor unit is
5-8mm.
Air deflector motor
Indoor unit
Ceiling
Air outlet
Buckle
Pipe mouth
Sealing materials
Hook
5-8mm
Decoration panel
AMS-SVX02A-EN
Advertisement
Table of Contents
