Launch X-431 User Manual page 94

LAUNCH
Notes:
1. Wait about 10s and begin to communicate since the Batterybox needs to initialize after connection is complete,
otherwise, communication may fail.
2. Red LED on the Batterybox means it has been successfully powered up. If the green LED is always on, it indicates
the clip is well connected; while the green light blinks, it indicates that the clip has poor contact. Do not perform
any test until the clip and data cable are properly connected.
2). Inside the vehicle test
Battery test and charging system & actuation system test can be done in this mode.
1. Battery test
Enter the battery test main menu screen, and select a desired test environment.
Note: The sequences of inside the vehicle and outside the vehicle test are almost the same, but under inside
the vehicle condition, all loads in vehicles must be powered off for getting an exact test value.
1. Firstly, the system detects whether floating electricity exists or not before testing. If yes, turn on the
headlamp to remove it. Otherwise, the system starts test program directly.
2. Tap or click [Inside the vehicle], the system starts detecting floating electricity automatically. If floating
electricity is detected, it will prompt you to turn on the headlamp.
3. Follow the on-screen instructions to turn on headlamp, the system starts removing floating electricity.
4. Once the floating electricity is removed, a prompt message box "The floating electricity has been
removed, please turn off the headlamp to continue the testing" will appear on the screen.
5. Follow the on-screen instructions to turn off the headlamp and tap [OK], the system will continue the
testing. Tap or click
6. Select a testing standard except for JIS and tap
capacity size by tapping on < or > or by dragging the slider on the bar.
www.x431.com +86 755 8455 7891
Batterybox Main Menu Screen
, it will enter testing standard selection screen.
Fig. Battery-1
to enter the following figure. Users can adjust
Station
User's Guide
89