Trouble Shooting And Specification - CareCo Minimus MS01097 User Manual

9. TROUBLE SHOOTING AND SPECIFICATION

TROUBLE SHOOTING
Symptom
The scooter will not switch on
The scooter switches on, but the scooter will not
move
The scooter appears slow
The seat turns when in operation
The handlebar appears loose
Involuntarily horn sounds
WARNING! DO NOT edit programme control!
Flash Description
Code
1 Low Battery
2 Motor Fault
3 Wiring Fault
4 Brake Fault
5 Over temperature or current fold-
back
6 Charger Fault
7 Throttle Fault
8 Controller Fault
9 Brake Fault
10 High Voltage
Remedy
• Try recharging the battery
• Check the fuse and circuit breaker in the
scooter
Ensure there is enough power in the batteries.
•
If not, recharge the batteries.
Ensure the freewheel lever is engaged in the
•
'DRIVE' position.
Check the battery power level and recharge
•
Check the speed dial is not set to slow.
•
Slowly rotate the seat until it drops into place
•
and is secure
Tighten the height adjustment handle to
•
secure the handlebar
Ensure that the wigwag paddle is released.
•
Switch the scooter off and on.
•
Recharge the batteries.
•
If problem persists contact your Minimus
•
dealer.
Recommended Action
Recharge battery
Check the motor connections, wiring and brushes
Check the connections/wiring between the motor
and batteries
Check the brake connections and wiring
The controller is over temperature or in current fold-
back
Disconnect the charger from the scooter
Make sure the throttle is not engaged when turning
on the scooter
Check the controller connections and wiring
Check the brake connections and wiring
If driving downhill slow down and turn lights on. Test
the charger to ensure that it cuts off when batteries
are full charged.
33