Trouble Shooting And Specification - CareCo TITAN Owner's Manual

7. T R O U B L E S H O O T I N G A N D S P E C I F I C AT I O N
■ TROUBLE SHOOTING
Symptom
The scooter will not switch on:
The scooter switches on, but
the scooter will not move:
The scooter appears slow:
The seat turns
operation:
The handlebar appears loose:
Horn sounds involuntarily:
The LED lights will 'blink' if there is a problem with your Titan scooter. The list below will assist
you in identifying any possible malfunction.
1 blink
2 blinks
3 blinks
6 blinks
7 blinks
8 blinks
10 blinks An excessive voltage has been applied to the control
Remedy
 Try recharging the batteries
 Check the fuse and circuit breaker in the scooter
 Ensure there is enough power in the batteries; if not,
recharge.
 Ensure the freewheel lever is engaged in the 'DRIVE'
position.
 Check the battery power level and recharge
 Check the speed dial is not set to slow.
when in  Slowly rotate the seat until it drops into place and is
secure
 Tighten the height adjustment handle to secure the
handlebar
 Ensure that the wigwag paddle is released.
 Switch the scooter off and on.
 Recharge the batteries.
 If problem persists contact CareCo.
The batteries need charging
Check the connections to the motor
There is a short circuit to a battery connection.
Contact CareCo Customer Service.
The battery charger may still be connected.
Disconnect the charger.
Ensure the throttle lever is in the 'stop' position.
Switch off for 5 seconds then switch on again.
A control system fault is indicated.
Ensure all connections are secure.
system. This is usually caused by a poor battery
connection. Check the battery connections.
20