Battery Charging And Care; Charging The Battery - CareCo Minimus MS01097 User Manual

7. BATTERY CHARGING AND CARE

7.1 CHARGING THE BATTERY

Follow the procedure below step by step:
1. Turn the power switch to (OFF)
2. Connect the charger's power cord into the power outlet.
3. Open the charging socket cap on the battery pack.
Then connect the charger's round plug to the charging
socket.
4. Turn on the switch on the charger.
5. Both the charger's red and orange LEDs will be lit when
beginning charging. The charging duration is about 6
hours. To ensure optimum performance a 10-hour charge is recommended. But
we do not recommend a charging more than 24 consecutive hours.
6. Both the charger's LEDs will be lit during the charging process. The orange LED
will turn green when charging is complete.
7. Turn off the charger; disconnect the power cord and the round plug from
charger socket on the scooter.
This charger meets IP21 (The charger detail specifications. Ref To the
" BATTERY CHARGER AND BATTERY")
Suggestions
There is a charger inhibit function on your scooter. The scooter will not run and the
battery condition meter will not operate while the batteries are charging.
WARNING!
1. To prolong charger life, do not connect the short output for long time.
2. Though charger charge automatically and can be used for deeply
discharged battery, do not use for extremely discharged, short aged and
defective battery.
3. Use the charger in a well-ventilated area.
4. Use for Lithium batteries 25.2V.
5. Do not use for voltage input except the specified. (Make sure your pres-
ent voltage input 110V or 240V and adjust manually)
25