Trouble Shooting And Specification - CareCo Zoom Usage And Maintenance Instructions

Zoom Mobility Scooter - MS01033
20

7. Trouble shooting and Specification

Symptom
The scooter will not switch on:
The scooter switches on, but the scooter will not move:
The scooter appears slow:
The seat turns when in operation:
The handlebar appears loose:
Horn sounds involuntarily:
If you experience any technical problems, it is recommended that you check with CareCo before attempting to
resolve any issues.
The following symptoms could indicate a serious problem with your power scooter. Contact CareCo if any of the
following arise:-
1. Motor noise
2. Frayed harnesses
3. Cracked or broken connectors
4. Uneven wear on any tyre
5. Jerky motion
6. Pulling to one side
7. Bent or broken wheel assemblies
8. Scooter does not power up
9. Powers up, but does not move
www.careco.co.uk
Remedy
• Try recharging the batteries.
• Check the fuse and circuit breaker in the scooter.
• Ensure there is enough power in the batteries;
if not, recharge.
• Ensure the freewheel lever is engaged in the
'DRIVE' position.
• Check the battery power level and recharge.
• Check the speed dial is not set to slow.
• Slowly rotate the seat until it drops into place
and is secure.
• Tighten the height adjustment handle to secure
the handlebar.
• Ensure that the wigwag paddle is released.
• Switch the scooter off and on.
• Recharge the batteries.
• If problem persists contact CareCo.
CareCo, Hubert Road, Brentwood, Essex, CM14 4JE