Veris Industries E34 Series Installation Manual page 30

E34 Series Installation Guide
Gateway Configuration
(cont.)
Z207251-0C Page 30 of 42
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
BACnet IP mode adds another field called BBMD_Enable. See the section BBMD Support for a full description of how to enable and
use BBMD support.
3. SNMP mode
SNMP mode uses four unique parameters. The SNMP_Community strings are used to control access to the device. Whatever values
are entered here must also be used in the MIB browser or SNMP access software to communicate with this device. The
Read_Community string is used to enable reading data. The Write_Community string is used to enable writing data. The
Trap_Community string is used to enable the receipt of event notifications.
The last parameter, SNMP_Notif_IP is used to set the IP address of the client that will be used to receive SNMP event notifications,
such as alarms.
Operating the E34E
Restart the E34E by using the button at the bottom of the GUI or by cycling the power. It takes about 30 seconds to initialize
completely and be ready for external communication.
BACnet Network Management – Important Steps to Avoid Conflicts
BACnet configuration uses two default settings that might need to be changed, depending on the application.
©2020 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
TM
0420