Gateway Configuration - Veris Industries E34 Series Installation Manual

E34 Series Installation Guide

Gateway Configuration

Z207251-0C Page 22 of 42
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR
ARC FLASH
• This product must be installed inside a suitable fire and
electrical enclosure.
• Follow safe electrical work practices. See NFPA 70E in
the USA, or applicable local codes.
• This equipment must only be installed and serviced by
qualified electrical personnel.
• Do not use this product for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read, understand and follow the instructions before
installing this product.
• Turn off all power supplying equipment before working on or
inside the equipment.
• Product may use multiple voltage/power sources.
Disconnect ALL sources before servicing.
• Use a properly rated voltage sensing device to confirm that
power is off. DO NOT depend on this product for voltage
indication.
• Current transformer secondaries (current mode) must be
shorted or connected to a burden at all times.
• Products rated only for basic insulation must be installed on
insulated conductors.
• Replace all doors, covers and protective devices before
powering the equipment.
• The installer is responsible for conformance to all applicable
codes.
Failure to follow these instructions will result in
death or serious injury.
A quali ed person is one who has skills and knowledge
related to the construction and operation of this electrical
equipment and installations, and has received safety training
to recognize and avoid the hazards involved. NEC Article 100
If this product is used in a manner not speci ed by the
manufacturer, the protection provided by the product may be
impaired. No responsibility is assumed by the manufacturer
for any consequences arising out of the use of this material.
Accessing the Graphical User Interface (GUI) - E34E Models Only
Note: The screen captures in this section were taken using Windows 7; other operating systems will look different.
If the E34E IP address parameters are already configured to work on the network and are being accessed from a PC on that same
network, then open a web browser and enter the IP address of the E34E into the address/URL field on the browser. Press Enter. If
this is the first time logging into the device, follow the instructions in "Accessing the GUI for the First Time with Firmware Version
1.027 or Higher" on page 37 of this installation guide to configure the web server's security settings and log in. If already
configured, the The GUI login page appears. Enter the username and password and click Login. The GUI launches and appears, as
shown, in the browser window below.
Note: Devices with firmware prior to version 1.027 will not have a login page and will not require a password.
©2020 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
TM
0420