Veris Industries E34 Series Installation Manual page 25

E34 Series Installation Guide
Gateway Configuration
(cont.)
Z207251-0C Page 25 of 42
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
e. Select Use the following IP Address. Make note of the IP address that appears, then enter the static IP address (e.g. if the
E34E is still set to its default address of 192.168.1.24, then change it to 192.168.1.100). Enter 255.255.255.0 for the subnet mask.
f. Click OK.
3. Open a PC web browser and enter the IP address of the E34E (default address is 192.168.1.24) to access the GUI. If this is the first
time logging into the device, follow the instructions in "Accessing the GUI for the First Time with Firmware Version 1.027 or
Higher" on page 37 of this installation guide to configure the web server's security settings and log in. The GUI launches and
appears in the browser window.
4. To set IP address parameters, click the button labeled Network Settings at the bottom of the page.
The Network Settings overlay appears.
Have the desired IP settings ready in advance (contact the system administrator). IP parameters for use with BACnet IP are
static, not dynamic.
5. Set the IP address for use on the BACnet/IP network:
©2020 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
Enter static
IP address
Enter subnet
mask
TM
0420