Operation - Raven RS1 Installation Manual

For massey ferguson 8600/8700 and challenger mt6x5c/d/e

Hide thumbs Also See for RS1:

8. Connect the 12-pin Deutsch connector to the mating connector on the back of the RS1 unit.

9. Feed other end of the RS1 cable towards the mating connector on the machine's roof.

10. Remove the cap off the mating roof connector.

11. Connect the 12-pin Amphenol connector to the mating roof connector.

FIGURE 7. Completed Cable Connection

12. Connect the RS1 Breakout Cable (P/N 115-4010-052) to the 6-pin DTM connector on the RS1 Roof Adapter

Cable.

13. Route the other end of the cable down the right-rear corner post and into the cab through the grommet at the

bottom of the rear window.

14. Connect the engage foot switch (P/N 063-0172-470) to the 2-pin DT connector.

OPERATION

Refer to the RS1 Calibration and Operation Manual (P/N 016-4010-001) for instructions on configuring, calibrating,

and operating RS1. Please note the location of the master switch on the machine as it is needed for operation.

FIGURE 8. Master Switch and Resume Foot Switch

Manual No. 016-5033-152 Rev A1. EC31824 08/18

Master Switch

Resume Foot Switch