Installation Steps; Installation Conditions Check; Installation Procedure - Ecosoft SENSE Installer And User Manual

INSTALLATION AND OPERATION GUIDELINES FOR REVERSE OSMOSIS FILTER ECOSOFT SENSE

4. INSTALLATION STEPS

Carefully read this manual before installing the reverse osmosis system.

4.1. INSTALLATION CONDITIONS CHECK

1. Check that all parts are in the package. Do not open the plastic bags with filter parts before you make
sure everything is in place to be able to return faulty/incomplete package.
2. Check conformity of your local variables to requirements specifications:
• verify that your product is as specified in paragraph 2.1;
• verify that your supply water quality meets the requirements in paragraph 2.2.
3. Before installing the system, make sure there is enough space for both the filter rack and the pressure
tank. In case there is not enough available space, pressure tank can be placed in a separate location
provided that the yellow tube's length is sufficient to connect it to the rest of the system.
4. Install the system in accordance with below procedure.

4.2. INSTALLATION PROCEDURE

CAUTION!!
! This system has been tested by the manufacturer for leaks, so within the system the
presence of residual water is allowed.
Wash your hands thoroughly with anti-bacterial soap before handling tubes, cartridges, and
membrane.
This system should desirably be installed in places protected from direct sunlight and away
from heating appliances.
1.
Remove the reverse osmosis system from its packaging and check the equipment.
2.
Shut off water supply in your kitchen or whole home and open water tap where you are about to install the
system (on your kitchen sink) to relieve pressure in the system, and then close it.
3.
Screw the feed adapter 6 into the cold water plumbing. the feed valve 7
into the feed adapter 6. To help prevent water leaks use PTFE sealing
tape.
Connections size is selected to fit most common size ½ inch pipe. If your
pipe is of another size, prepare an appropriate adapter.
4.
Unscrew the compression nut from the feed valve 7 and put it on the red tube. Push the
red tube on the end of feed valve's fitting 7 and screw on the compression nut. Connect
the free end of the red tube with the quick connect fitting under the «INLET» mark on the
back of the filter unit.
5.
Connect the drain saddle 10 with drain pipe from the kitchen sink. The
drain saddle is compatible with most standard drain pipes. Drill a hole of
5.0 mm (0.2") diameter in the kitchen sink drain pipe, apply rubber gasket
with sticky base (included in the package). Install the drain saddle 10
on the drain pipe over the hole. Tighten screws on drain saddle with a
screwdriver. Insert black tube into the connection on the clamp.
Connect the other end of the black tube with the quick connect fitting
under the «DRAIN» mark on the back of the filter unit.
CAUTION!!! Check if the flow regulator is installed in the black tube
in the end connected to membrane housing.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2019
9