Ecosoft SENSE Installer And User Manual page 10

INSTALLATION AND OPERATION GUIDELINES FOR REVERSE OSMOSIS FILTER ECOSOFT SENSE
10
6.
Put a few turns of PTFE tape on tank nipple thread.
Screw tank 8 valve on the tank nipple.
IMPORTANT! Check air pressure in empty tank.
Tank should be pressurized to 0.4-0.6 bar (5.8-
8.7 psi). If necessary, use a pump with a pressure
gauge to increase the pressure or push the core of
the valve stem to relieve pressure.
7.
Installation of the faucet
7.1. To install drinking water faucet 5 drill 12.5
mm (1/2") diameter hole in a convenient
location at the sink or countertop.
CAUTION!!!
damage
carefully as soon as you have drilled
the hole. If the mounting surface is
ceramic or stone, you may need a
special carbide drill.
7.2. Mount the faucet on the sink or countertop
as shown on the figure. Nut, lock washer
and plastic washer on the faucet shank
must fix the faucet firmly on the surface.
7.3. Take the blue tube, put on compression
nut, ferrule, and put plastic insert inside,
in that order.
7.4. Push the end of blue tube inside the
shank bottom, seat the ferrule against
shank bottom and screw compression
nut snugly on shank thread. The faucet
should now be firmly fixed on top of
sink, and blue tube tightly seated in
compression fitting at the bottom of
faucet shank.
8.
Insert cartridges into the first and the second housings in the direction of
water flow.
9.
Tighten all the three sumps by hand.
10.
Open a pre-filters rinse valve.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2019
Metal shavings
your unit, remove
can
them
small rubber gasket
chrome-plated cover
large rubber gasket
large plastic gasket
lock washer
nut
counter
plastic insert
1/4 ferrule
1/4 compression nut
blue tube
tank valve
PTFE seal
tank
12,5 mm
(1/2")
17 mm
(2/3")