Ecosoft SENSE Installer And User Manual page 11

INSTALLATION AND OPERATION GUIDELINES FOR REVERSE OSMOSIS FILTER ECOSOFT SENSE
11.
Open the feed valve 7 and let through the first two pre-filters with cartridges 5-7 liters (1.5-2 gallons) of water to
wash off the carbon fines (black in colour) that may appear in cartridges during shipping. Then close feed valve
before installing the third cartridge.
CAUTION!!! This water will pour through the open valve, prepare a vessel to collect it
12.
Insert the cartridge into the third housings and screw it. Open the water
supply for 5-10 minutes to rinse the carbon filter. Then close feed and
pre-filters rinse valves.
13.
Install the membrane into the membrane housing.
CAUTION!!! When installing reverse osmotic membrane,
do not take it out of the bag. Cut the bag at the opposite
end to membrane's brine seal, push the membrane inside
membrane housing. Do not touch membrane surface at any
time.
14.
Leave the feed valve 7 and purified water faucet 5 open for 30 minutes. Then open the tank valve 8. Close the
faucet 5 and carefully check all connections for leaks.
CAUTION!!! The first week after installation, check the system daily for leaks, do it periodically in the
future.
If you are leaving for a long time such as for a business trip or vacation, shut off the water supply.
15.
Let the water tank get filled (you will hear the water stop flowing), drain all water from the tank by opening the
faucet 5 until the flow goes to a drip or slow dribble. After the tank has been emptied, close the faucet 5 so that
the tank starts re-filling. Filling of the tank may take about 1 hour.
Purified water can be slightly turbid after installation. Drain several additional tanks of purified water. The water
can be used now.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2019
11