Launch X-431 PAD V User Manual page 78

LAUNCH
3 Data Cable
4 Power adapter
Battery clamps
5
cable
6 20:1 Attenuator
74
Connects the Scopebox and diagnostic
tool so that the sampled signal can be
displayed on the diagnos c tool.
To supply power to the Scopebox through
connection to AC outlet.
To supply power to the Scopebox through
connection to vehicle's battery.
It allows the Scopebox to measure fuel
injector and primary igni on waveforms.
*Note: Please note this attenuator
should be not used for any high voltage
measurements other than fuel injectors
and primary ignition.
Crocodile Clip
This ignition pick-up is applied in the
following situa ons: Secondary-distributor
igni on analysis, Secondary-simultaneous
ignition analysis and Secondary-direct
igni on analysis.
It has three ends: BNC connector (for
Secondary
connec ng to CH1/CH2/CH3/CH4),
7
ignition pick-up
crocodile clip (for Grounding) and high-
voltage clip (for connec ng high-voltage
line), near which has an a enuator
equipped for high-pressure a enua on
to prevent the Scopebox from being
impacted.
*Notes:
1). The high voltage clip should be
clamped on the insulated lead (COP
Extension Cord, see Item 8) instead
of on the spark plug to prevent
breakdown and electric shock.
2). Please try to keep an instance of 2 inch
from other high-voltage line to avoid
the interference.
User's Manual
PAD V
BNC Connector
High-voltage Clip