Reports - Launch X-431 PAD V User Manual

LAUNCH
*Notes:
• On-load voltage refers to the charging voltage when there is a load. It
evaluates the on-load capacity of the generator. When different auto
parts are opened, the load voltage will be generated. The on-load
voltage will greatly vary depending on the auto parts being opened.
• The operating time required for charging health test varies from
person to person. If the engine does not start or accelerate within 30
seconds, the system will prompt you "receiving timeout" and return to
the initial status.
• Whether Engine is off or not has no influence on charging health test
result after increased speed is detected, but other loads need to be
powered off.

7.2.5 Reports

7.2.5.1 Generate Reports
This option is used to save the reports after the battery health test,
start system test and the charging health test are successfully
performed.
Follow the steps below to proceed:
1. Tap "Generate Report" on the battery main menu, the system will
detect which tests are made before. If the test is successfully done,
it will be selected by default. If you do not plan to generate a report
for this test, just tap it to deselect it.
70
2. Tap the input box below the vehicle information, a virtual keyboard
will pop up on the screen. Use the keyboard to enter the license
plate.
3. After inputting, tap "Save report" to enter the report details page.
4. Tap "Save" to save it. The saved report will be stored in the
"Historical Reports".
To share the report to the car owner, tap "Share" and the QR code
User's Manual
PAD V