Launch X-431 PAD V User Manual page 63

LAUNCH
*Note: The sequences of inside the vehicle and outside the vehicle test are
almost the same, but under inside the vehicle condition, all loads in vehicles
must be powered off for getting an exact test value.
1. Firstly, the system detects whether fl oating electricity exists or not
before testing. If yes, turn on the headlamp to remove it. Otherwise,
the system starts test program directly.
2. Tap [Inside the vehicle], the system starts detecting floating
electricity automatically. If floating electricity is detected, it will
prompt you to turn on the headlamp.
3. Follow the on-screen instructions to turn on headlamp, the system
starts removing fl oating electricity.
4. Once the fl oating electricity is removed, a prompt message box "The
fl oating electricity has been removed, please turn off the headlamp
to continue the testing" will appear on the screen.
5. Follow the on-screen instructions to turn off the headlamp and
tap [OK], the system will continue the testing. Tap
testing standard selection screen.
6. Select a testing standard except for JIS and tap
following fi gure. Users can adjust capacity size by tapping on < or >
or by dragging the slider on the bar.
If JIS is selected, tap
capacity screen. Users can select corresponding standard capacity
value according to battery model marked on battery.
, it will enter 7. Tap and the testing result will appear on the following screen.
[ ]: Tap it to perform the charging system and starting system test.
to enter the
[ ]: Tap to test it again.
User's Manual
PAD V
, the system will enter Select testing
59