Table of Contents
Advertisement
12
MENU
SPEED 1-8
Set Speeds 1-8 in Schedule Mode
In Schedule mode, Speeds 1-8 can be programmed
to run a certain speed at a certain time of day. To run
a scheduled speed, press Start/Stop. The screen will
display "Running Schedules" when it is ready to run
a scheduled speed. If Start/Stop is pressed while a
scheduled speed is running, "Running Speed _" will be
displayed.
1. Press Menu.
2. Use Up or Down arrows to scroll to "Speed 1-8",
then press Select.
3. Use Up or Down arrows
speed you wish to set and schedule.
4. Press Select (display will be highlighted) and
scroll to "Schedule".
5. Press Enter.
6. Press
Down arrow ("Set Speed" will display) and
press Select to change. Use the Up or Down
arrow to adjust speed.
7. Press Enter to save the new speed.
Down arrow again, "Set Start Time" will
8. Press the
display.
Press Select -
minute column.
9. Use the Up or Down arrow to change the time
and the
Left or Right
minutes to hours.
10. Press Enter to save the new start time setting.
Down arrow -"Set StopTime"will
11. Press
Select. Repeat Steps 8-9 to set stop time.
12. Press Enter to save the new stop time setting.
13. Press Start/Stop.
The Sparus
™
Pump with Constant Flow Technology will
prime and begin to run the programmed schedule at the
specified start time.
When running in Schedule or Egg Timer mode, the
countdown time (T 00:01) showing the hours and
minutes remaining is displayed.
Programming Schedule for Constant Run
A speed cannot be programmed with the same start
and stop times. To run a speed without stopping, set
the Start time one minute after the stop time.
Example: A single speed will run non stop if programmed
with a Start Time of 8:00 AM and a Stop time of 7:59 AM.
SPARUS
Pump with Constant Flow Technology Installation and User's Guide
™
Pump Menu: Speeds 1-8
Manual
Speed 1 (1-4)
Schedule
Egg Timer
Disabled
Speed 5 (5-8)
Schedule
and press
Select
the cursor will highlight the
arrow to move cursor from
display.Press
Set Speed - Default: MANUAL
Set Speed
Set Start Time
Set Stop Time
Set Speed
Time
Schedule
Default: Disabled
Set Speed
Set Speed
Set Start Time
Set Stop Time
Note: The pump will not run the scheduled speeds until the
Start/Stop button is pressed (LED on) to place the pump in
Schedule mode.
for the
Note: When two speeds are scheduled during the
same run time the pump will run the higher RPM Speed
regardless of Speed # in use.
Note: The most recent command, Manual or Schedule,
takes priority regardless of speed number RPM.
12:15p
1100 RPM
T 1:05
150 WATTS
Running Speed 1
12:15p
Advertisement
Table of Contents
