AJA Ki Pro Ultra Machine Control Manual page 20

3.25 Selected EE – Status Data Byte 4, Bit 7
The device does not support Selected EE, however this bit will be set if the
Selected EE On command has been sent. It will be cleared upon edit completion.
3.26 Edit Preset A1 – Status Data Byte 5, Bit 0
This bit reflects the A1 edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.27 Edit Preset A2 – Status Data Byte 5, Bit 1
This bit reflects the A2 edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.28 Edit Preset LTC – Status Data Byte 5, Bit 2
This bit reflects the LTC edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.29 Edit Preset Video – Status Data Byte 5, Bit 4
This bit reflects the Video edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.30 Edit Preset Assemble – Status Data Byte 5, Bit 5
This bit reflects the Assemble edit preset value set by the Edit Preset command.
This device has limited edit support. Please refer to the "Editing" section below
for further details.
3.31 Edit Preset Insert – Status Data Byte 5, Bit 6
This bit reflects the Insert edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.32 Reverse Lamp – Status Data Byte 6, Bit 4
This bit will be high whenever the device's transport is moving in reverse.
3.33 Forward Lamp – Status Data Byte 6, Bit 5
This bit will be high whenever the device's transport is moving forward.
3.34 Still Lamp – Status Data Byte 6, Bit 6
This bit will be high whenever the device's transport is still.
Ki Pro Ultra Products Machine Control Guide v3.0 20 www.aja.com