AJA Ki Pro Ultra Machine Control Manual page 19

3. 1 5 Shuttle – Status Data Byte 2, Bit 5
This bit will be high whenever the device has received a shuttle playback
command. It will be cleared whenever the device enters a mode outside shuttle
playback.
3. 1 6 Servo Lock – Status Data Byte 2, Bit 7
This bit will be high whenever the device is in normal forward playback or record
and has started rolling. Status Data Byte 3, Bit 0 – In Set
This bit will be high whenever the edit in point has been set.
3. 1 7 In Set - Status Data Byte 3, Bit 0
This bit will be high whenever the edit in point has been set.
3. 1 8 Out Set – Status Data Byte 3, Bit 1
This bit will be high whenever the edit out point has been set.
3. 1 9 Audio In Set – Status Data Byte 3, Bit 2
The device does not support split audio editing, however to maintain
compatibility with typical controllers, this bit will be set whenever the video in
point is set.
3.20 Audio Out Set – Status Data Byte 3, Bit 3
The device does not support split audio editing, however to maintain
compatibility with typical controllers, this bit will be set whenever the video in
point is set.
3.21 Cue Up Complete – Status Data Byte 4, Bit 0
This bit will be high when a cue up operation has completed. It will be cleared on
the start of a subsequent cue operation.
3.22 Auto Edit – Status Data Byte 4, Bit 2
This bit will be high when auto edit has been started. It will be cleared by the
completion of the auto edit either by success or failure.
3.23 Edit – Status Data Byte 4, Bit 4
This bit will be high when an edit operation has started. It will be cleared when
the edit operation has completed.
3.24 Full EE – Status Data Byte 4, Bit 6
The device does not support full EE, however this bit will be set if the enable Full
EE On command has been sent. It will be cleared if the Full EE Off command has
been sent.
Ki Pro Ultra Products Machine Control Guide v3.0 19 www.aja.com