AJA Ki Pro Ultra Machine Control Manual page 13

2.27 Cue Up with Data – 0x24 0x31
This command is used for cueing up the DEVICE to the position assigned by the
time data of DATA-1 through DATA-4. Units of respective data are as follows:
2.28 In Entry – 0x40 0x10
2.29 Out Entry – 0x40 0x11
These two commands are used for storing the value of the TIMER or the TIME
CODE data, which is displayed on the DEVICE, into the IN, OUT memory as IN
POINT, OUT POINT data.
2.30 A In Entry – 0x40 0x12
Split audio editing is not supported by Ki Pro or Ki Pro Ultra Plus Ultra, however
this command will respond with ACK to maintain compatibility with typical
controllers.
2.31 A Out Entry – 0x40 0x13
Split audio editing is not supported by Ki Pro or Ki Pro Ultra Plus Ultra, however
this command will respond with ACK to maintain compatibility with typical
controllers.
2.32 In Preset – 0x40 0x14
2.33 Out Preset – 0x40 0x15
These two commands are used for presetting the value, which has been given by
the DATA-1 to DATA-4, into the IN or OUT memory.
For the data format, see
2.34 A In Preset – 0x40 0x16
2.35 A Out Preset – 0x40 0x17
Split audio editing is not supported by Ki Pro, however these two commands will
respond with ACK to maintain compatibility with typical controllers.
2.36 In Shift + (plus) – 0x40 0x18
2.37 In Shift – (minus) – 0x40 0x19
These two commands are used for adding or subtracting the value of the TIME
DATA, which has been stored as IN POINT, by one frame.
Ki Pro Ultra Products Machine Control Guide v3.0
"2.27 Cue Up with Data – 0x24 0x31" on page 13
13 www.aja.com