AJA Ki Pro Ultra Machine Control Manual page 12

PREROLL TIME is fixed at 5 seconds.
IN POINT is defined by the "In Entry – 0x40 0x10" command.
2. 1 9 Auto Edit – 0x20 0x42
This command initiates an auto edit. Please see the section below labeled
"Editing" for details on how editing functionality is implemented on the Ki Pro
Ultra.
2.20 Full EE Off – 0x20 0x60
This command has no real effect on the device. The device will, however, track the
state of Full EE in the "Full EE" status bit.
2.21 Full EE On – 0x20 0x61
This command has no real effect on the device. The device will, however, track the
state of Full EE in the "Full EE" status bit.
2.22 Selected EE On – 0x20 0x63
This command has no real effect on the device. The device will, however, track the
state of Selected EE in the "Selected EE" status bit. This bit will be cleared upon
edit completion.
2.23 Edit Off – 0x20 0x64
This command stops an edit. There is a three frame delay between when the
edit off command is received and when the edit actually stops. Please see the
"Editing" section below for details on how editing functionality is implemented
on the Ki Pro Ultra.
2.24 Edit On – 0x20 0x65
This command starts an edit. There is a three frame delay between when the
edit on command is received and when the edit actually starts. Please see the
"Editing" section below for details on how editing functionality is implemented
on the Ki Pro Ultra.
2.25 Set Clip – 0x24 0xE0
This command sets the current clip index from the currently selected playlist. It
takes a four byte payload containing the 32 bit unsigned integer clip ID. The first
payload byte sent is the least significant byte of the 32 bit clip ID. This will cause
the device to cue up to the beginning of the set clip ID and go into still playback.
2.26 Next/Prev Clip – 0x21 0x31
This command, when supplied with the following payloads, will cause the device
to jump the next or previous clip in the currently selected playlist. The following
payload bytes are accepted:
• 0x01 – Next Clip
• 0xFF – Previous Clip
Ki Pro Ultra Products Machine Control Guide v3.0 12 www.aja.com