AJA Ki Pro Ultra Machine Control Manual page 11

2. 1 1 Jog Forward – 0x2X 0x11
This command jogs the device similar to a VTR. It takes a one or two byte payload
as defined in
responds with ACK, but will do so before the transport state has changed. Use the
status bits to determine when the device has actually changed state.
2. 1 2 Var Forward – 0x2X 0x12
This command initiates variable speed playback similar to a VTR. It takes a one
or two byte payload as defined in
This command responds with ACK, but will do so before the transport state has
changed. Use the status bits to determine when the device has actually changed
state.
2. 1 3 Shuttle Forward – 0x2X 0x13
This command shuttles the device similar to a VTR. It takes a one or two byte
payload as defined in
command responds with ACK, but will do so before the transport state has
changed. Use the status bits to determine when the device has actually changed
state.
2. 1 4 Rewind – 0x20 0x20
This command puts the device in rewind playback. This is roughly 20x real time
speed. This command responds with ACK, but will do so before the transport
state has changed. Use the status bits to determine when the device has actually
changed state.
2. 1 5 Jog Reverse – 0x2X 0x21
This command jogs the device similar to a VTR. It takes a one or two byte payload
as defined in
responds with ACK, but will do so before the transport state has changed. Use the
status bits to determine when the device has actually changed state.
2. 1 6 Variable Reverse – 0x2X 0x22
This command initiates variable speed playback similar to a VTR. It takes a one
or two byte payload as defined in
This command responds with ACK, but will do so before the transport state has
changed. Use the status bits to determine when the device has actually changed
state.
2. 1 7 Shuttle Reverse – 0x2X 0x23
This command shuttles the device similar to a VTR. It takes a one or two byte
payload as defined in
command responds with ACK, but will do so before the transport state has
changed. Use the status bits to determine when the device has actually changed
state.
2. 1 8 PreRoll – 0x20 0x30
When this command is received, the DEVICE is prerolled to the tape position that
is obtained by subtracting the preroll time from the IN POINT.
Ki Pro Ultra Products Machine Control Guide v3.0
"Speed Data Payload Description" on page
"Speed Data Payload Description" on page
"Speed Data Payload Description" on page
"Speed Data Payload Description" on page
"Speed Data Payload Description" on page
"Speed Data Payload Description" on page
11
10. This command
10.
10. This
10. This command
10.
10. This
www.aja.com