AJA Ki Pro Ultra Machine Control Manual page 16

2.57 Timer Mode Sense – 0x60 0x36
This command has no effect on the device. It will respond with ACK to maintain
compatibility with typical controllers.
2.59 Current Time Sense – 0x61 0x0C
This command is used for requesting the TIME DATA. The DEVICE will make a
response according to the content of DATA-1.
When accurate time data is requested in the normal playback mode, the
following condition must be satisfied.
• Select external reference mode.
• CURRENT TIME SENSE command and its return must be completed within the
field-2.
[DATA-1] The response command to the request command is as follows.
This command also provides USER'S BIT responses, but only for RS-422
compatibility. Ki Pro Ultra devices do not store actual user bit information in the
resulting Quicktime files. Instead userbits are always set to 00000000, and this
value will be returned in the response, rather than an ACK.
2.60 Status Sense – 0x61 0x20
This command is used for requesting the status of the DEVICE.
It specifies the data to be sent back by the "7X.20 : STATUS DATA" command
according to DATA-1 added to this command.
MSD (BIT-7 to 4) : Indicates the starting DATA No. of the data to be sent back.
LSD (BIT-3 to 0) : Indicates the number of data bytes (1H to FH) to be sent back.
Example.
When the DATA-1 of this command is "2A", the STATUS DATA of the DEVICE will
send back ten bytes from the DATA No.2, i. e.
DATA No.2 to DATA No.B.
See "Chapter 3 Status Data"
2.61 Error Code Sense – 0xF0 0xEE
Returns AJA proprietary error code information.
Ki Pro Ultra Products Machine Control Guide v3.0
for a list of supported status bits.
16 www.aja.com