AJA Ki Pro Ultra Machine Control Manual page 18

3.4 Fast Fwd – Status Data Byte 1, Bit 2
This bit will be high whenever the device is in forward playback at a rate of 20x or
higher.
3.5 Rewind – Status Data Byte 1, Bit 3
This bit will be high whenever the device is in reverse playback at a rate of 20x or
higher.
3.6 Eject – Status Data Byte 1, Bit 4
This bit will be high whenever the device is in the process of shutting down.
3.7 Stop – Status Data Byte 1, Bit 5
This bit will be high whenever the device is in still playback.
3.8 Tension Release – Status Data Byte 1, Bit 6
This bit will be high whenever the device is in the process of shutting down.
3.9 Standby – Status Data Byte 1, Bit 7
This bit will be high whenever the device is not in capture mode.
3. 1 0 Cue Ok – Status Data Byte 2, Bit 0
This bit will be high whenever a cue up command completes. It will be cleared
on the next cue command (and subsequently go high again when that cue
command completes).
3. 1 1 Still – Status Data Byte 2, Bit 1
This bit will be high whenever the device is in still playback.
3. 1 2 Reverse – Status Data Byte 2, Bit 2
This bit will be high whenever the device is in reverse playback (this includes jog/
shuttle/var/rewind).
3. 1 3 Var – Status Data Byte 2, Bit 3
This bit will be high whenever the device has received a variable speed playback
command. It will be cleared whenever the device enters a mode outside variable
speed playback.
3. 1 4 Jog – Status Data Byte 2, Bit 4
This bit will be high whenever the device has received a jog playback command.
It will be cleared whenever the device enters a mode outside jog playback.
Ki Pro Ultra Products Machine Control Guide v3.0 18 www.aja.com