Usage And Maintenance; Warning - Fenix HP30R Quick Start Manual

1. Attach the headband to the headlamp as shown, by first sliding the band down to the bottom
of the slots. Then hook the top edge under the top slot.
2. Adjust the headband by sliding the buckle to required length.
3. Use the clips and buckles provided to retain the headlamp cable in the headband or top
headband mount.
4. Connect the battery case male terminal to the headlamp cable female terminal, and attach the
battery case to the belt.

Usage and Maintenance


Disassembling the sealed head can cause damage to the headlamp and will void the
warranty.

Fenix strongly recommends using quality disposable or rechargeable Lithium battery.

Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring
with an approved spare．

Periodic cleaning of the battery contacts improves the lamp's performance as dirty contacts
may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following
reasons:
A: The batteries need replacing.
Solution: Replace batteries (Ensure batteries are inserted according to the manufacturer's
specifications).
B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don't work, please contact your authorized distributor.

Warning

The headlamp is a high-intensity lighting device capable of causing eye damage to the user or
others. Avoid shining the light directly into anyone's eyes.
The headlamp will accumulate a lot of heat after working in highest mode for an extended period
of time. Do not touch any metal part of the lamp head to prevent scalding.