Page 1
Fenix HP30R Headlamp Indication switch Locking nut Micro USB port Spotlight switch USB port Floodlight switch Spotlight Floodlight Technical Parameters Spotlight Mode Floodlight Mode ANSI/PLAT O FL1 Turbo High Turbo High 1000 Lumens Lumens Lumens Lumens Lumens Lumens Lumens Lumens...
Page 2
IP66 Water Resistance Notice: The abovementioned parameters (lab-tested by using two Fenix 3.6V/2600mAh rechargeable 18650 Li-ion batteries) may vary between headlamps, batteries and environments. ◎ Uses Cree XM-L2 and XP-G2 R5 LED’s with a lifespan of 50,000 hours ◎ Powered by two 18650 or four CR123A batteries ◎...
Page 3
SOS Mode In any state, press and hold the floodlight switch for 1.2 seconds to enter SOS mode. Click to return to previous state. The SOS output is the same as the floodlight Med level. Intelligent Overheat Protection The headlamp will accumulate a lot of heat when high output levels are used. To avoid high surface temperature: 1.
Page 4
Fenix ARB-L18 18650 batteries are recommended. 2. Do not mix batteries of different brands, sizes, capacities or types. Doing so may cause damage to the headlamp or the batteries being used.
Page 5
Disassembling the sealed head can cause damage to the headlamp and will void the warranty. Fenix strongly recommends using quality disposable or rechargeable Lithium battery. Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare....
Need help?
Do you have a question about the HP30R and is the answer not in the manual?
Questions and answers