Table of Contents
Advertisement
Security precautions
•
Installation of the Dreamoc must be done according to this manual, and must be performed by an adult
(Over 21 years).
•
The Dreamoc must be placed on a horizontal, stable and plane surface.
•
Do not install the Dreamoc in narrow passageways or other places where a lot of people and equipment has to pass close
by, thereby risking collisions that might cause the Dreamoc to tip over causing human injuries and damage to property.
•
The Dreamoc must be connected to a power outlet with current and voltage as described in the product factsheet
•
During service and cleaning the Dreamoc must be turned off, and the power plug removed from the outlet. To
disconnect the apparatus from the mains, the plug must be pulled out from the mains socket, therefore the mains
plug shall be readily operable.
•
Handle the OLED/LCD display with care. The OLED/LCD is a very delicate display device: Do not press its sur-
face with excessive force, hit it or prick it with a sharp object.
•
No sand or dust! Fine sand or dust entering the system could cause malfunctions or defects.
•
No water or oil! Water or oil entering the system could cause electric shock, malfunctions or defects.
•
The surface of the system will be slightly warm when using, but this does not indicate a fault.
•
Environmental conditions: Operating Temperature 0 °C to 35 °C , Operating Humidity 10 % to 80 %, Storage
Temperature -20 °C to 60 °C, Storage Humidity 5 % to 80 %
•
Do not place the Dreamoc in direct sunlight or near magnetism, corrosive gas or ultrasonic humidifier. This could
cause malfunction.
•
Do not expose the Dreamoc to soot or steam. Thick soot or steam could damage the electrical components and
cause malfunctions.
•
Keep the SD-card out of reach of children to prevent swallowing.
•
Important: When you have mounted the 2 picture engine modules make sure to attach the rubber protectors on
each corner to prevent an injury when further assembling the display. See video
•
Always remember to secure ground the metal chassis to appropriate electrical installation ground.
3
Advertisement
Table of Contents
