Color Reproduction Adjustment - Sony DCR-HC65 Adjusting Manual

10. Color Reproduction Adjustment

Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
Subject Color bar chart
(Color reproduction adjustment frame)
(1.0m (PTB-450) or 0.4m (PTB-1450)
from the front of the lens)
Measurement Point Video terminal of AUDIO/VIDEO jack
Measuring Instrument Vectorscope
Adjustment Page F
Adjustment Address 37, 39, 40, 41
Specified Value All color luminance points should settle
within each color reproduction frame.
Note: The data of page: 0, address: 10 must be "00".
Switch setting:
1) MODE ......................................................... CAMERA-TAPE
2) NIGHT SHOT .................................................................. OFF
3) FOCUS .................................................................. MANUAL
4) DIGITAL ZOOM (CAMERA SET menu) ...................... OFF
5) STEADY SHOT (CAMERA SET menu) ........................ OFF
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 6, address: 9D, and set data: 20.
3) Select page: 6, address: 01, set data: 3D, and press the PAUSE
button.
4) Select page: F, address: F0, set the data: 37, and press the
PAUSE button.
5) Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
6) Change the data of page: F, address: 37, 39, 40 and 41, and
settle each color luminance point in each color reproduction
frame.
Note: Be sure to press the PAUSE button of the adjustment remote
commander before changing the addresses. If not, the new data
will not be written to the memory.
Processing after Completing Adjustments:
1) Select page: 6, address: 01, set data: 00, and press the PAUSE
button.
2) Select page: 6, address: 9D, and set data: 00.
3) Select page: 0, address: 01, and set data: 00.
Burst position
6-29
DCR-HC65
Fig. 6-1-11.