Steady Shot Check - Sony DCR-HC65 Adjusting Manual

16. Steady Shot Check

Precautions on the Parts Replacement
There are two types of repair parts.
Type A : ENC03MA
Type B : ENC03MB
Replace the broken sensor with a same type sensor. If replace with
other type parts, the image will vibrate up and down or left and
right during hand-shake correction operations.
Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care
as if it dropped, the balance of the oscillator will be disrupted and
operations will not be performed properly.
Subject Arbitrary
Measurement Point Display data of page 1 (Note1)
Measuring Instrument Adjustment remote commander
Specified Value 2680 to 5080
Note1: Displayed data of the adjustment remote commander.
1 : XX : XX
Display data
Note2: The data of page: 0, address: 10 must be "00".
Switch setting:
1) STEADY SHOT (CAMERA SET menu) ......................... ON
2) ZOOM .................................................................... TELE end
Adjusting method:
Order Page Address Data
1 0 03 11
2 1
3 0 03 12
4 1
5 0 03 00
6
Note3: Don't move the camcorder.
Procedure
Pitch sensor check
(CD-513 board SE401)
Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note3)
Yaw sensor check
(CD-513 board SE402)
Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note3)
Set the data.
Move the camcorder, and check
that the steady shot operations
have been performed normally
6-33
DCR-HC65