White Balance Check - Sony DCR-HC65 Adjusting Manual

DCR-HC65

15. White Balance Check

Subject
Filter
Measurement Point
Measuring Instrument
Specified Value 1
Specified Value 2
Specified Value 3
Note1: Perform "Auto White Balance Adjustment" before this adjustment.
If not performed, the specified value of "Outdoor white balance
check" may not be satisfied.
Note2: The data of page: 0, address: 10 must be "00".
Note3: Perform "11. Picture Frame Setting (All White Frame)".
Note4: Displayed data of the adjustment remote commander.
1 : XX : XX
Display data
Switch setting:
1) MODE ......................................................... CAMERA-TAPE
2) NIGHT SHOT .................................................................. OFF
3) FOCUS .................................................................. MANUAL
4) DIGITAL ZOOM (CAMERA SET menu) ...................... OFF
5) STEADY SHOT (CAMERA SET menu) ....................... OFF
Checking method:
Order Page Address Data
1
2 6 01
3 0 03
4 1
5 6 01
6 6 01
7 0 03
8 1
9 6 01
10
11 0 03
12 1
Note5: If the specified value is not satisfied. Contents of the error are
displayed at the lower digit (bit0 to bit3) of the display data. (For
the bit values, refer to "6-4. SERVICE MODE", "4-3. 4. Bit value
discrimination".)
bit0=1: B-Y data exceeded an upper limit
bit1=1: B-Y data exceeded a lower limit
bit2=1: R-Y data exceeded an upper limit
bit3=1: R-Y data exceeded a lower limit
Clear chart (All white frame)
(1.0m (PTB-450) or 0.4m (PTB-1450)
from the front of the lens) (Note3)
ND filter 1.0 and 0.4 and 0.1
Display data of page 1 (Note4)
Adjustment remote commander
8000 to FFF0
8000 to FFF0
8000 to 8BC0
Procedure
Check that the picture frame is
"All white frame". If not,
perform "11. Picture Frame
Setting (All White Frame)".
Outdoor white balance check
4F Set the data, and press PAUSE
button.
33 Set the data.
Check that the display data
(Note4) satisfies the specified
value 1. (Note5)
00 Set the data, and press PAUSE
button.
Indoor white balance check
0F Set the data, and press PAUSE
button.
33 Set the data.
Check that the display data
(Note4) satisfies the specified
value 2. (Note5)
00 Set the data, and press PAUSE
button.
LV data check
Place the ND filter 1.5
(1.0+0.1+0.4) on the lens.
06 Set the data.
Check that the display data
(Note4) satisfies the specified
value 3.
Processing after Completing Adjustments
Order Page Address Data
1 0 03
2 6 01
3 6 90
4 6 91
5 6 92
6 6 93
7
6-32
Procedure
00 Set the data.
00 Set the data, and press PAUSE
button.
00 Set the data.
00 Set the data.
00 Set the data.
00 Set the data.
Remove the ND filter.