Color Reproduction Adjustment - Sony DSC-S70 Service Manual

10. Color Reproduction Adjustment

Adjust the color separation matrix coefficient so that proper color
reproduction is produced.
Mode STILL
Subject Color bar chart
(Color reproduction adjustment frame)
Adjustment Page F
Adjustment Address 41 to 48, 5C to 5F
Note 1: Perform "Auto White Balance Standard Data Input"
before this adjustment.
Note 2: Check that the data of page: 6, address: 02 is "00".
If not, turn the power of unit OFF/ON.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 5, address: F1, and set data: FF.
3) Select page: D, address: 63, set data: 40, and press the PAUSE
button of the adjusting remote commander.
4) Perform " Data setting during camera system adjustment".
(Refer to page 5-13)
5) Select page: 6, address: 01, set data: AB, and press the PAUSE
button.
6) Select page: 6, address: 12, set data: 80, and press the PAUSE
button.
7) Wait for 1 second.
8) Select page: 6, address: 12, set data: 00, and press the PAUSE
button.
9) Wait for 2 seconds.
10) Select page: 6, address: 01, set data: A9, and press the PAUSE
button. (The color reproduction adjustment is performed and
the adjustment data is stored in page: F, address: 41 to 48,
5C to 5F)
11) Select page: 6, address: 02, and check that the data is "01".
Processing after Completing Adjustments:
1) Select page: 6, address: 01, set data: 00, and press the PAUSE
button of the adjusting remote commander.
2) Select page: 5, address: F1, and set data: 00.
3) Select page: D, address: 63, set data: 00, and press the PAUSE
button.
4) Release the data setting performed at step 4).
(Refer to page 5-13)
5) Select page: 0, address: 01, and set data: 00.
6) Perform "Color Reproduction Check".
5-20