11. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
11-1. Color Reproduction Adjustment
Mode
Subject
Adjustment Page
Adjustment Address
Note 1: This adjustment should be carried out upon completion of "Auto
White Balance Standard Data Input" and "Color Reproduction
Adjustment".
Note 2: Check that the data of page: 6, address: 02 is "00". If not, turn the
power of the unit OFF/ON.
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2)
Select page: E, address: 52, after noting down the data, set
data: 0B, and press the PAUSE button of the adjustment remote
commander.
3)
Select page: 5, address: F1, and set data: FF.
4)
Check that the picture frame is set to the specified position.
(Refer to "5. Picture Frame Setting".)
5)
Select page: 6, address: 10, and set data: 59.
6)
Select page: 6, address: 01, set data: AB, and press the PAUSE
button.
7)
Select page: 6, address: 01, set data: A9, and press the PAUSE
button.
(The color reproduction adjustment is performed and the
adjustment data is stored in page: F, address: 41 to 48.)
8)
Select page: 6, address: 02, and check that the data is "01".
9)
Perform "Color Reproduction Check" and "Processing after
Completing Adjustments".
Downloaded from:
https://www.usersmanualguide.com/
STILL
Color bar chart
(Color bar standard picture frame)
F
41 to 48
For NTSC model
Burst postion
11-2. Color Reproduction Check
Mode
Subject
Measurement Point
Measuring Instrument
Specified Value
Checking method:
1)
Select page: 0, address: 01, and set data: 01.
2)
Select page: E, address: 52, after noting down the data, set
data: 0B, and press the PAUSE button of the adjustment remote
commander.
3)
Select page: 5, address: F1, and set data: FF.
4)
Select page: 6, address: 10, and set data: 59.
5)
Select page: 6, address: 01, set data: 3D, and press the PAUSE
button.
6)
Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
7)
Check that each center of all color luminance points is settled
in each color reproduction frame.
8)
Perform "Processing after Completing Adjustments".
11-3. Processing after Completing Adjustments
1)
Select page: E, address: 52, set the data noted down at step 2),
and press the PAUSE button of the adjustment remote
commander.
2)
Select page: 6, address: 10, and set data: 00.
3)
Select page: 6, address: 01, set data: 00, and press the PAUSE
button.
4)
Select page: 5, address: F1, and set data: 00.
5)
Select page: 0, address: 01, and set data: 00.
For PAL model
Burst postion
Fig.5-1-15.
5-25
STILL
Color bar chart
(Color reproduction adjustment frame)
Video output terminal
Vectorscope
Each center of all color luminance
points should settle within each color
reproduction frame.