Table of Contents
Advertisement
1.800.561.8187
Fyrite
InTech
Manual
Step
"Measured" is the current temperature reading. "Applied" is a known
temperature that will be applied for calibration purposes.
Set thermocouple simulator to 32° F (0° C), and then use the UP (), DOWN
4
(), LEFT (), and RIGHT () arrow buttons to enter an Applied value that
exactly equals the setting of the simulator.
Alternatively: Submerge probe tip into an ice-water bath with a thermometer,
wait several minutes, and then use the UP () and DOWN () arrow buttons
to enter an Applied value that exactly equals the thermometer reading.
NOTE: The calibration range is from 32 to 41° F (0 to 5° C). An
attempt to calibrate outside this range will cause the message
"Applied Value High" (or Low) to appear at the bottom of the
screen.
5
Wait until the Measured reading stabilizes, and then press ENTER to calibrate
the TS-Zero Measured value to that of the Applied value, after which the
message "Good Calibration" should briefly appear followed by the CALIBRATE
TS-SPAN screen.
6
Set thermocouple simulator to 572° F (300° C), and then use the UP (),
DOWN (), LEFT (), and RIGHT () arrow buttons to enter an Applied value
that exactly equals the setting of the simulator.
Alternatively: Submerge probe tip into a container of boiling water with a
thermometer, wait several minutes, and then use the arrow buttons to enter
an Applied value that exactly equals the thermometer reading.
NOTE: The calibration range is from 175 to 625° F (80 to 329° C).
An attempt to calibrate outside this range will cause the message
"Applied Value High" (or Low) to appear at the bottom of the
screen.
0024-9486 Rev 4
www.
Calibration and Maintenance
T-STACK Calibration Procedure
.com
57
information@itm.com
Advertisement
Table of Contents
