Javad OMEGA User Manual page 16

Parameter
Implicit Message Output
Period
Elevation mask angle
File name prefix
FN key mode
Initial dynamic mode
Click Apply every time after the parameter was
Note:
changed, otherwise the receiver won't save the changes. Click
Refresh, to ensure the changed parameters and new configura-
tion are saved.
Figure 5.
Figure 6.
5. Open Positioning tab and set the Elevation
mask to 15 degrees .
16
Base Rover
15 seconds
15 degrees
Enter a unique ID, such as the last 3 digits
of receiver's serial number. By deafault the
prefix is log
(starts/stops the data recording when FN
button is used)
Select LED blink Select Occupation
mode switch for mode switch
Static data RTK)
- Select Dynamic (for
trajectory survey)
Log Files tab
TriPad tab
(for
Figure 7.
6. To set up the base station, open the Base tab and
set the following parameters: Antenna Phase Center
Position (APC) - enter latitude, longitude, and altitude
(ellipsoidal height) values of the antenna position. Do
one of the following:
• If known, type in the values.
• Click Get from receiver to use the current antenna
position.
7. Restart your receiver. Open the Base tab and
check coordinates. Click Refresh, to refresh the pa-
rameters.
7. To set up the rover, open Positioning tab and set
the Position Computation Mode - this drop-down list
box allows selecting the mode of position computa-
Elevation mask
Base tab
Figure 8.
www.javad.com