Settings/Modifications/On-Site Adaptation; Using The Keyboard For Programming; Code Input - Meiko TopClean Operating Instructions Manual

15 Settings/modifications/on-site adaptation

15.1 Using the keyboard for programming

Increase value/
move forward
Function field
Various access codes were defined for the various user levels. After the complete code
has been entered, it is compared to an internal code table. The corresponding user level
is then granted, depending on the code that has been entered.
Two access codes are available for each user level; the first is for restricted access, i.e.
no modification of parameters is possible (viewing mode), and the second gives access to
the entire range of functions (viewing and modification).
In the short programming instructions accompanying every appliance in the series, this is
described in condensed form.
For control system programming, the power supply must be available and the appliance
must be completely switched off (no LED is illuminated).

Code input:

View service data:
Modify service data:
View configuration data:
View dosing technology data:
Modify dosing technology data:
The code numbers for the additional levels can be taken from the service manual.
15.2 Code input
To access code input mode, hold down the "0" button (for about 3 seconds) until you see
Pressing the "0" button again lets you quit programming at any time.
The digit being changed flashes.
Press the "I" button to increase the value/code indicated on the display unit, or press the
"III" button to decrease it, and press the "accept" button to save it. The next value will then
flash and will be the only one visible.
Decrease value/scroll
back
Value field
CODE 10000
CODE 10001
CODE 20000
CODE 40000
CODE 40044
23 / 42
Accept/modify
in the display.
Exit
9742146