Table of Contents
Advertisement
Off button
Programme start
button
CAUTION!
CAUTION!
CAUTION!
9742146
8
Shutting down the appliance
•
Press the "0" button (off button). The machine is switched off when all the lights are
out.
•
To empty the tank, press the programme start button if the emptying and self-
cleaning programme is not automatically started by turning off the machine.
After the tank water has been drained, the tank is flushed with clean hot water. The
•
door must remain closed. The drain pump is switched off automatically.
9
Maintenance and care
9.1
Care, general
The appliance has been designed to keep the need for cleaning, care and maintenance
to a minimum.
However, for reliable, safe and long-term function of the machine, and in the interest of
hygiene and cleanliness, correct care and maintenance is necessary. To facilitate this
effort, a maintenance contract can be concluded with the manufacturer or its
representative.
Incorrectly performed procedures, the use of unauthorised parts, and repairs by
unqualified personnel endanger both the operators and the machine and will void your
warranty.
9.2
Refilling chemical disinfectants and cleaning agents
The container is located in the immediate vicinity of the appliance.
Check the filling level of the container and if necessary, replace it with a full one.
Only non-foaming, approved disinfectants, cleaning agents and rinse aids that are
authorised for disinfection machines may be used. (see the section on chemistry for the
operation of the appliance)
If a functional defect is suspected, check the dosing equipment for the chemical
disinfectants and cleaning agents. Visual inspection!
9.3
Refilling with rinse aid
The container is located in the immediate vicinity of the appliance.
Check the level and, if necessary, replace the container with a full one.
Only non-foaming acidic rinse aids (pH < 7) that are approved for disinfection machines
may be used (see the chapter "Chemicals for operating the machine").
If you suspect a malfunction, check the final rinse dosing unit for proper function. Visual
inspection!
9.4
Cleaning
After emptying the tank, proceed as follows:
• Do not use a foaming detergent for pre-cleaning in the vicinity of the unit. In appliances,
foam can cause unit malfunctions and a poor wash.
• Residues sticking to the tank, tank heating element and sieves must be removed with a
brush.
• Remove the rotating arms and rinse them using running water.
• Clean the cleaning nozzles daily.
• Check the rinse aid nozzles weekly for cleanliness and rinse them using running water,
if required.
16 / 42
Advertisement
Table of Contents
Troubleshooting
