Side-Release Battery Cover & Casing - Giant MY20 Service Manual

4.4 ENERGYPAK-BATTERY
SIDE-RELEASE BATTERY COVER & CASING
DISASSEMBLE:
To remove the battery covers: Start with the rear end of the battery as
1
pictured. Use a tire-lever to prevent damage. Start at the corner of the
cover, lift it up until the first hook snaps out of its groove.
Continue to lift and snap the next hook out of its groove.
2
Turn the battery around to the front end. Lift up the corner of the cover
3
and snap the first hook on this side out of its groove. Continue all the way
down the length of the battery, until the topside of the cover is completely
released.
On the bottom side of the battery cover there are "L" shaped hooks.
4
Don't pull the cover. Just hold it lightly and lift the battery up a bit. The
hooks should release without any force. Gently push the cover downward
if necessary.
Start with the cover on the other side, at the corner on the rear end of the
5
battery.
65