Battery Capacity Tester & Cable - Giant MY20 Service Manual

3.5 BATTERY CAPACITY TESTER & CABLE
G-system battery quality can be checked quickly and easily with the Service
Tool Software, so the Battery Capacity Tester (5481-test-06V) is not neces-
sary for these batteries. For discharging EnergyPak battery, the capacity
tester is still usefull.
A
A: Power On/Off switch
Switches the tester On or Off.
B: Battery Connector Socket
For connecting the battery to the tester with a battery connector cord.
- 147LMHDC000-02 for integrated G-System batteries
- 147LMHDBXXX-01 for all other G-System batteries
The supplied extension cord can be used if necessary.
C: Display Screen
Shows the value of the selected mode.
When the value is flashing, it indicates that the value can then be adjusted.
D: Display Mode Indicators
- Voltage LED is on: The display shows the Voltage value of a connected
battery.
When the display is flashing, it shows the set termination Voltage at which
the discharge test will stop.
- Current LED is on: The display shows the current value of the battery.
When the value is flashing, it shows the discharge current that will be
applied during the test.
- Time LED is on: The display shows the elapsed time of the discharge
test.
- Capacity LED is on: The display shows the capacity that was released
from the batterypack during the test
- Discharge LED is OFF: The tester is on standby.
- Discharge LED is RED: The testing is in progress.
- Discharge LED is GREEN: The testing is finished.
E: Selector switch
The switch can be rotated to select a display mode.
Push the switch to enter the setting for the selected mode. Rotate the
swith to change the value. Push it again to confirm the changes and exit
the setting mode.
F: Start & Stop button
The Start button to start the test
Press the Stop button to cancel the test.
B C D E F
37