Mm712 Media Module Specifications; Mm717 Media Module Specifications; Mm710B Media Module Specifications - Avaya G450 Overview And Specification

- 10,000 feet (3048 meters) with a 0.4 mm wire
With ringer load of .1 or less, the supported loop length is 20,000 feet (6096 meters) with a
0.65 mm, 0.5 mm, and 0.4 mm wire.
• Up to 24 simultaneously ringing ports
• Type 1 caller ID
• Ring voltage generation for a variety of international frequencies and cadences
The MM716 media module is compatible with Avaya Aura
and later, and Branch Gateway firmware version 29.x.x and later.

MM712 media module specifications

The MM712 DCP media module provides eight DCP telephone ports. The ports support two-wire
Digital Communications Protocol (DCP) phones. For a list of compatible DCP phones, see
Supported Avaya phones

MM717 media module specifications

The MM717 DCP media module provides 24 DCP ports of two-wire DCP functionality exposed as
a single 25-pair amphenol connector. The DCP ports are exposed by connecting the module via a
standard amphenol cable to a punch-down block with RJ-11 jacks. The MM717 media module
allows you to use one of the smaller media module slots for a large number of DCP phones.

MM710B media module specifications

The MM710B E1/T1 media module terminates an E1 or T1 trunk. The MM710 media module has
a built-in Channel Service Unit (CSU), therefore, an external CSU is not necessary. The CSU is
only used for the T1 circuit.
Note:
The information in this section applies to the MM710 media module as well.
April 2020
on page 53.
Avaya G450 Branch Gateway Overview and Specification
Comments on this document? infodev@avaya.com
Telephony media modules
®
Communication Manager Release 3.1
27