Starting And Ending The Charging Process Via App - Wallbe MAX Instruction Manual

Instruction manual
When the authorization was successfull, the follo-
wing message is displayed:
The charging process starts then automatically. The
status LED now shines blue. During the charging
process, the display shows the current charging po-
wer, the charging current and the charging time for
your selected charging point:
3. When the desired state of charge has been reached,
you can stop the charging process by opening the
central locking of your vehicle or end the charging
process at your charging station with a RFID chip or
RFID card. The following message is then displayed:
Driving eMobility
Note: When the vehicle is fully charged, the vehicle
will automatically stop charging.
Note: In case of power failure, the charging plug is
automatically unlocked by the lock release module.
4. Disconnect the charging cable from the electric ve-
hicle. To do this, follow the instructions of your ve-
hicle's instruction manual.
5. Then disconnect the charging cable from the char-
ging station.
6. Stow the charging cable carefully back in your vehic-
le.

6.4.2 Starting and ending the charging process via app

1. When have selected app as your payment method,
use an appropriate app. You can use the wallbe® app
or the app of another billing service provider (e.g.
plugsurfing) where you are registered. Use the help
or instructions for the app of the respective provider
to familiarise yourself with the app used. Follow the
instructions of the app.
2. The charging station is then activated. The status
LED flashes alternately green and blue. The follo-
wing image appears on the display:
11/19