Starting And Ending The Charging Process With Rfid - Wallbe MAX Instruction Manual

Instruction manual
4. When the desired state of charge has been reached,
you can stop the charging process by opening the
central locking of your vehicle. The following mes-
sage is then displayed:
Note: When the vehicle is fully charged, the vehicle
will automatically stop charging.
Note: In case of power failure, the charging plug is
automatically unlocked by the lock release module.
5. Disconnect the charging cable from the electric ve-
hicle. To do this, follow the instructions of your ve-
hicle's instruction manual.
6. Then disconnect the charging cable from the char-
ging station.
7. Stow the charging cable carefully back in your vehic-
le.

6.2.2 Starting and ending the charging process with RFID

1. When you have selected RFID as your payment met-
hod, hold the RFID card or chip in front of the card
reader, which is located on the right or left side of the
charging station, depending on the selected charging
point.
2. Follow afterwards the instructions on the payment
terminal.
Driving eMobility
3. The charging station is then activated. The status
LED flashes alternately green and blue. The follo-
wing image appears on the display:
When the authorization was successfull, the follo-
wing message is displayed:
The charging process starts then automatically. The
status LED now shines blue. During the charging
process, the display shows the current charging po-
wer, the charging current and the charging time for
your selected charging point:
7/19