Description Of The Charging Station - Wallbe MAX Instruction Manual

Instruction manual
or adapter.
• Always make sure to remove the charging cable
from the vehicle before driving off.
• Any changes to the charging station are not permit-
ted. There is a risk of electric shock and damage to
the charging station. Any changes to the charging
station will void the warranty with immediate effect.
• Never clean the charging station with harsh cleaning
agents, high pressure water jet cleaners and steam
jet cleaners.
• Never immerse the charging cable in in water or any
other liquid.
• Assembly, electrical connection, commissioning,
maintenance and repair may only be carried out by a
qualified electrician. The qualified electrician must be
registered in the installer directory.
• If further trades are required for assembly, the ne-
cessary activities may only be carried out by trained
specialists.
• No liability will be accepted for damage during trans-
port if the product is transported in anything other
than the original packaging.
• At all times, observe the local safety regulations for
the country in which you operate the device.
Driving eMobility

3 DESCRIPTION OF THE CHARGING STATION

The following figure shows the wallbe® MAX charging
station. Depending on the variant ordered, the optical
appearance differs from the figure.
A
B
Figure 1: Overview of wallbe® MAX
A
Display
B
Contactless card reader
C
PIN pad (optional)
D
magnet and chipcard reader (optional)
C
D
4/19