Table of Contents
Advertisement
Installation manual
come into contact with heat sources, dirt or water.
• Never put your fingers in the socket of the charging
station.
• Do not step on the charging cable or bend it.
• Do not pull the plug out of the socket by the cable.
Pulling on the charging cable may damage the char-
ging cable or the locking mechanism.
• Never remove the charging cable by force. Dange-
rous arcs can cause serious injury or death.
• Unroll the charging cable completely to avoid over-
heating.
• Use only standard-compliant charging cables (accor-
ding to EN 62196-1, EN 62196-2 and EN 50620).
• Do not use the charging cable with an extension cord
or adapter.
• Ensure that the charging cable, when connected to
the charging station and the vehicle, does not block
any paths.
• Pay attention to the charging cable lying on the
ground when the charging cable is connected to the
vehicle and charging station. There is a risk of trip-
ping.
• Always make sure to remove the charging cable
from the vehicle before driving off.
• Never immerse the charging cable in in water or any
other liquid.
• The charging station may only be installed and ope-
rated with the supplied cover, mounting plate and
cable holder.
• No liability will be accepted for damage during trans-
port if the product is transported in anything other
than the original packaging.
• At all times, observe the local safety regulations for
the country in which you operate the device.
Driving eMobility
3 ASSEMBLY
3.1 Choice of location
• Do not install the charging station near flammable or
explosive materials.
• If possible, mount the charging station protected
from direct sunlight.
• The charging station must not be installed in places
where it blocks escape routes or passages for peo-
ple.
• The charging station must not be installed in pla-
ces where it is exposed to direct water jets (e.g.
high-pressure cleaners or car washes).
• Do not install the charging station in areas that are
at risk of flooding.
• Observe the permissible ambient conditions (see
chapter 6).
3.2 Mounting of the wall charging station
The following accessories are required:
• 3 countersunk head screws, 6 mm, for holes (A) and
(B), not included in the scope of delivery
• 4 screws, 8 mm, for holes (C), included in the scope
of delivery
• 4 dowels, 8 mm, for holes (C), included in the scope
of delivery
• 4 screws M4, included in the scope of delivery
• 4 self-sealing washers (with the rubber side facing
the wall), included in delivery
4/18
Advertisement
Table of Contents
