Table of Contents
Advertisement
Note: Use only original replacement parts. This will protect your warranty coverage for parts
replaced under warranty.
Contact authorized dealers of this product.
If they can't supply original replacement
parts, call Customer Service toll free at
1-866-573-0674 for referral information.
When calling Customer Service or your dealer,
have ready:
• Your name
• Your address
Contact authorized dealers of this product.
If they can't supply original replacement
part(s) call Customer Service toll free at
1-866-573-0674 for referral information.
Purchase these heater accessories from your local dealer. If they can not supply these ac-
cessories, contact ProCom Heating, Inc. for information.
EQUIPMENT SHUTOFF VALVE
For all models. Equipment shutoff valve with
1/8" NPT tap.
OPTIONAL FAN KIT
Optional fan kit part PF06-YJLF-B. The fan
has 3 settings ON/OFF/Auto.
Please refer to PF06-YJLF-B instructions.
200233-01B
REPLACEMENT PARTS
PARTS UNDER WARRANTY
PARTS NOT UNDER WARRANTY
ACCESSORIES
www.usaprocom.com
• Model and serial number of your heater
• How heater was malfunctioning
• Type of gas used (Propane/LP or Natural
gas/NG)
• Purchase date
• Usually, we will ask you to return the defec-
tive part to the factory
When calling Customer Service have ready:
• Model number of your heater
• The replacement part number
25
- Quick Links:
- Specifications
- Installation
- Operation
- Troubleshooting
- Replacement Parts
- Parts
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MNSD300HGA and is the answer not in the manual?
Questions and answers
I cant get the pilot light to light I followed the instructions correctly ??
To troubleshoot the pilot light issue on a Procom MNSD300HGA:
1. Check Gas Supply – Ensure the equipment shutoff valve is fully open.
2. Follow Lighting Instructions – Turn the control knob to OFF, wait five minutes, then try lighting the pilot again by pressing the ignitor button.
3. Manual Lighting – If the ignitor does not work, light the pilot with a match following the Manual Lighting Procedure (page 18).
4. Hold Control Knob – After lighting, keep the control knob pressed for 30 seconds.
5. Check Gas Pressure – If the pilot does not stay lit, gas pressure may be too low. Contact your gas supplier.
6. Consult Troubleshooting Guide – Refer to pages 20-24 for additional troubleshooting steps.
7. Seek Professional Help – If the issue persists, contact a qualified service technician or gas supplier for repairs.
This answer is automatically generated