Table of Contents
Advertisement
1.3.
Connection - Video-Interface
The video-interface converts the connected after-market sources video signals into an RGB
digital signal which is inserted in the factory monitor using separate trigger options and it
reads vehicle's digital signals out of the vehicle's CAN-bus and converts them for the video
interface.
1.4.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the 8 dip-switches at the
video-interface. Dip position down is ON and position up is OFF.
Dip
Function
1
No function
2
CVBS Video 1-input
3
CVBS Video 2-input
4
No function
5
Rear-view cam type
6
No function
7
Monitor selection
8
See the following chapters for detailed information.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Version 12.09.2019
ON (down)
enabled
enabled
after-market
Try all possible combinations of dip 7 and 8 to find the
best picture (quality and size)
HW: CAM(V97)
OFF (up)
set to OFF
disabled
disabled
set to OFF
factory or none
set to OFF
RL3-UCON8-LV
Advertisement
Table of Contents
