Table of Contents
Advertisement
1.3.
Boxes and connectors – video interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options. Further it reads the vehicle's digital signals out of the vehicle's CAN-bus and
converts them for the video interface.
1.4.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the dip-switches of the
video interface.
Dip position down is ON and position up is OFF.
Dip
Function
1
No function
2
CVBS Video 1-input
3
CVBS Video 2-input
4
No function
5
Rear-view cam type
6
Guide lines
7
Monitor-specific
adjustments
8
In case of a non-optimal displayed picture with the mentioned dip settings of dip7 and dip8,
we recommend to try each other possible dip switch combination.
See the following chapters for detailed information.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
See the following chapters for detailed information.
Version 11.09.2019
ON (down)
enabled
enabled
after-market
guide lines enabled
6.5inch monitor: dip7 OFF / dip8 ON
8.8inch high resolution monitor: dip7 ON / dip8 OFF
8.8inch lower resolution monitor: dip7 OFF / dip8 OFF
HW:CAM (V98) / (V20)
OFF (up)
set to OFF
disabled
disabled
set to OFF
factory or none
guide lines disabled
CI-RL3-C3D
Advertisement
Table of Contents
