Audio-Insertion; After-Market Rear-View Camera - r.LiNK RL3-UCON8-LV Manual

Video-inserter with 2 video inputs,rear-view camera input and can control compatible with maserati vehicles with uconnect vp4-na and 8.4 inch monitor

Table of Contents

2.6.1. Audio insertion

This interface is only able to insert video signals into the factory infotainment. If an AV-

source is connected, the audio insertion has to be done by the factory audio AUX input or an

FM-modulator. The inserted video-signal can be activated simultaneously to each audio-

mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,

additional electronic is necessary to switch the audio signals.

Some vehicles have a different reverse gear code on the CAN-bus which the video-interface

is not compatible with. Therefore, there are two different ways of installation. If the video

interface receives a signal of the reverse gear, the green wire

"Reverse-OUT"

of the 12pin

cable should carry +12V while the reverse gear is engaged. See the following illustration for

the according connection.

Note: Do not forget to set dip5 of the video-interface to ON before testing.

Version 12.09.2019

HW: CAM(V97)

RL3-UCON8-LV

Table of Contents