Enabling The Interface's Video Inputs (Dip 2-3); Rear-View Camera Setting (Dip 5); Settings Of The 4 Dip Switches (Can Function - Red); Installation - r.LiNK RL3-UCON8-LV Manual

1.4.1. Enabling the interface's video inputs (dip 2-3)

Only the enabled video inputs can be accessed when switching through the interface's video
sources. It`s recommended to enable only the required inputs for the disabled will be
skipped when switching through the video-interfaces inputs.

1.4.2. Rear-view camera setting (dip 5)

If set to OFF, the interface switches to factory RGB digital picture while the reverse gear is
engaged to display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input
reverse gear is engaged.
Note: Dip 1, 4 und 6 are out of function and have to be set to OFF.
1.5.

Settings of the 4 Dip switches (CAN function - red)

Dip position down is ON and position up is OFF.
Navigation / System
All vehicles
For all vehicles, use the OFF position of all the 4 dip switches.
After each Dip-switch-change a power-reset of the Can-box has to be performed!

2. Installation

Switch off the ignition and disconnect the vehicle's battery! The interface needs a
permanent 12V source. If -according to factory rules- a disconnection of the battery has to
be avoided, it should be sufficient to use the vehicle's sleep-mode. In case, the sleep-mode
doesn't succeed, the battery has to be disconnected with a resistor lead.
The Interface needs a permanent power supply! If power isn't directly taken from the
battery, the connection's power has to be checked for being start-up proven and
permanent.
Before a final installation, we recommend a test-run to ensure the compatibility of the
vehicle and the interface. Due to changes in the production of the vehicle manufacturer
there's always a possibility of incompatibility.
Version 12.09.2019
Dip 1 Dip 2 Dip 3
OFF OFF OFF
HW: CAM(V97)
"Camera-IN" while the
Dip 4
OFF
RL3-UCON8-LV